4Home ControlPoint 2000 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 4Home ControlPoint 2000. 4Home ControlPoint 2000 20 pages.
2
Connection, Registration, and Activation
2.1 Using the Setup Wizard
To use the
Setup
Wizard, simply open a browser window and go to http://www.4homemedia.net. If you do not wish
to use the
Setup Wizard
Internet.
2.2 Connecting to the Internet
1.
Plug one end of the provided Ethernet cable into the
end into your router or switch/hub on your home network.
2.
Plug one end of the power cable into the
socket or power strip. The
3.
The
LAN
LED on the front of the ControlPoint will blink green until the ControlPoint has obtained an IP
address, at which point the
NOTE: Your ControlPoint is pre-configured to receive IP address automatically via the DHCP mechanism used
in most home networks. If no DHCP server is present on the network, your ControlPoint will default to the IP
address 192.168.1.55.
Once the ControlPoint is connected to the local network, it will connect to the Internet automatically. You'll
need the ControlPoint to have Internet connectivity so that you can
successfully
Registered
2
and would rather set everything up manually, continue to section
12V 1.0A
Power
LED on the front of the ControlPoint will turn solid green
LAN
LED will turn solid green. This can take up to two minutes
and
Activated
your ControlPoint, the
WAN Ethernet
port of your ControlPoint. Plug the other
port of your ControlPoint and the other end into a wall
Activate
and
Broadband
LED will turn solid green.
2.2 Connecting to the
Register
it online. Once you've
Connection, Registration, and Activation