DataBay AVE-304TR Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DataBay AVE-304TR. DataBay AVE-304TR 11 pages. Vga and audio cat-x av extender
Également pour DataBay AVE-304TR : Manuel de l'utilisateur (16 pages)

Imprimer la page

User Manual

PAIR

PAIR 1

JACK POSITION

The EIA/TIA defination of 568B in the pin assignment is

(1) orange white, () orange, () green white, (4) blue,

(5) blue white, (6) green, (7) brown white, and (8) brown

(4) Connect UTP Cable : Plug two ends of UTP cable to Transmitter

and Receiver's RJ45 SYSTEM LINK ports, the Receiver's connected

monitor and speaker should work now and the LEDs above RJ-45 port

should remain ON. You can adjust the "FOCUS" and "GAIN" control of

Receiver to have the best VGA display.

VGA Audio USB

in 1 Cable

Use Cat5e cable

Max : 00M

One-Port Transmitter

Installation Diagram of Receiver AVE-01R

(5) Function Test: After above installation, you will be able to broadcast the

AV signal to Receiver's connected monitor and speaker.

PAIR 4

Projector

PDP

LCD

VGA output Devices

One-Port Receiver

(6) Problem and Solving: If you find unstable image or audio problems

after installation, please confirm following list or contact your direct

vendor for further assistance:

a. Check if PC's VGA resolution and frequency over the limit of monitor

display, if so, please change the VGA configuration from Windows

Control panel.

b. Try to connect Monitor and speaker directly to a PC, and ensure the

basic function of these devices.

c. When using LCD or same type monitor, there might have some image

offset or blinking, please adjust the position, clock or phase of the

LCD monitor, or simply press Auto Adjust / Tune to have a better

image solution.

3. AVE-300 Multi-Port Model: Installation and Operation

(1) Site Selection: In your first time installation, place Transmitter near the

PC or AV devices; you can use rack mounting kit to fix the system box.

CRT

Rack Mounting kit for Multi-port Unit

() Connecting Monitor and Speaker: Plug power adapter to the

Transmitter and connect monitor and speaker to "VGA/AUDIO OUT"

port. The POWER LED will turn on green to indicate the POWER ON

status and "ACTIVE" LEDs should turn off to indicate the unconnected

status. Then, prepare VGA and audio cables to connect the signal

from your AV device to the "VGA/AUDIO IN" port of Transmitter box.