Addvent AVCIMF Series Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Addvent AVCIMF Series. Addvent AVCIMF Series 4 pages. Mixed flow extractor fans

Imprimer la page

N.B Make sure that once the extractor is installed there is no accidental access to the moving parts.

Electrical Connections

1. The extractor fan must be connected to a single phase mains network, 220 - 240VAC.

2. The installation must have an omnipolar switch with a contact separation of at least 3mm. The circuit

must be protected by a 3 Amp fuse.

3. Earthing is not required as this extractor is a class II insulated appliance.

4. The extractor must be connected permanently to a fixed installation cable secured in fixed

channelling. (Flex of two conductor wires of minimum section 1mm

To make the Electrical Connections

5. Loosen the 4 screws (A) and take off the connection cover

6. Perforate the flex holder (B) to allow the power supply wires to pass through.

7. Make the connections as indicated on the next page.

Mixflo fan

Flexible

screwed to joist

ducting

Internal White

Grille

Body can be rotated to accomodate tight spaces.

External

grey grille

and maximum 1.5mm

)