Durst M 670 COLOR Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Durst M 670 COLOR. Durst M 670 COLOR 16 pages.

12 13

---=.... ..::---1

"'1---20 2

(6) A mixing box (17) for film sizes up to 24 X 36 mm

(7) The negative carrier (7)

(8) Format masks (8) for 24X36 mm films

(9) A 12 volt 100 watt tungsten-halogen lamp (18)

(10) A lens board (11) for 50 mm lenses

(11) A spanner (12) with bolts (13) and backing plate (14)

(12) A blanking plate (19)

(13) A diffuser with retaining springs for diffused-light readings

with colour analysers or enlarging exposure meters.

Checking the contents

The Ourst M 670 BW or Ourst M 670 COlOR is shipped in a

special break-proof package. Please check that all parts are

included as listed in the above section. Before assembly

thoroughly clean and dust all components with a cloth.

Assembling the enlarger

Place the column (2) with the column base (3) on a table and

hold the baseboard (1) against the column base (3) so that you

can push the hexagonal bolts (13) through the backing plate

(14) and the holes of the baseboard (1) and column base (3).

Tighten these bolts with the spanner (12) supplied. Now place

the baseboard with the column attached on the table with

the rubber feet (20) down. Next attach the lower section of

the enlarger head (4) to the supporting stud (21) and secure

with the locking knob (22).

If your enlarger is the Durst M 670 BW, insert the lamp fitting

(9) from below into the lower section of the enlarger head (4).

Screw the 150 watt opal lamp (10) supplied into the lamp

holder (23).

Then mount the black-and-white condenser lamphouse (5) over

the lower section of the enlarger head (4) and secure with

the two milled screws (24).

Below the condenser lamphouse (5) attach the condenser (6)

supplied to the milled screws (25) provided for the purpose.

To do this, slack off the two milled screws, engage the two

cutouts of the condenser unit under the milled screws (25)

and screw the latter tight.

Plug the lead of the Ourst M 670 BW into the socket of an

exposure timer and connect the latter to the mains supply.

5625