DATAGRABBER RapidRH L6 with Bluetooth Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DATAGRABBER RapidRH L6 with Bluetooth. DATAGRABBER RapidRH L6 with Bluetooth 11 pages.

Imprimer la page

RAPID RH L6

Device Name: This will be the unique identifier of your

device. The device name can be up to 12 characters long.

NOTE: There will be a default name present in the Device

Name field, but you will likely want to rename it.

Acclimation Time: The amount of time elapsed (in days)

before the DataGrabber will automatically capture (grab) a

measurement and store in the L6 Smart Sensor's memory

as the acclimated time measurement of both RH and

temperature. For instance, setting an acclimation time of one

day and then starting, the DataGrabber will wait 24 hours and

"grab" a measurement for storage in the L6 Smart Sensor's

memory. In most cases, it is highly recommended to use

one day as the acclimation time, given that 24 hours is the

minimum equilibration time specified by the ASTM F2170

standard for getting official, documentable RH readings.

Log Interval: In addition to the reading captured (grabbed)

when the Acclimation Time has elapsed (see above), an

L6 sensor, through the DataGrabber with Bluetooth, will

begin to capture readings at a certain interval, defined as

the Log (datalogging) Interval. This datalogging of RH and

temperature readings begins as soon as the DataGrabber with

Bluetooth is inserted into the sensor, and a new set of readings

is logged everytime the Log Interval is met. The default and

minimum Log Interval is 1 hour.

Log Duration: A calculation of the total number of days that

periodic time and date-stamped readings will be taken based

on the set log interval and the L6 Smart Sensor's maximum

memory storage of 512 data points. Once this limit is reached,

the first stored reading will be overwritten.

Write Settings to Device: Whenever you change the

configuration of the DataGrabber, you must click the Write

Settings to Device button in order to save the settings.

Default Settings: If you wish to use the acclimation time and

log interval settings as the default settings for one or more

additional DataGrabbers, click the Save Defaults button. This

saves the settings displayed as your default settings. Then

select another DataGrabber and go to the Settings screen.

Click the Load Defaults button. The default settings will

now be displayed for this device. Be sure to also click the

Write Settings to Device button to save the default settings to

this DataGrabber.

Start and Stop: After you have saved the desired settings

and are ready to begin data logging, click the Start button to

signal to the DataGrabber to begin the acclimation time.

NOTE: The clock in the DataGrabber will automatically

synchronize to the clock on your mobile device.

TROUBLESHOOTING

If the DataGrabber with Bluetooth does not show up on the

DataMaster L6 Devices screen.

•

Check the connection between the DataGrabber and

the L6 Smart Sensor.

•

Ensure that the battery is seated properly or replace the

battery as necessary.

WAGNER METERS