Cayin m-50CD Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cayin m-50CD. Cayin m-50CD 16 pages. Vacuum tube compact disc player
Imprimer la page
Connection Diagram
Please make sure the following preparations are well done before using:
■ AC Power
1. Before connecting, make sure the power mark on the real panel is the same to the
power voltage of your area.
2. Be sure the Power Switch on the front panel of the CD Player is tuned off (in the
"
"
out
position).
3. Using the Power Cord (supplied), connect the Power Inlet on the CD Player's real
panel to the AC Power Outlet.
4. Press the Power Switch in. The Display will light up, indicating that the CD Player
is turned on.
5. To turn the CD Player off, press the Power Switch again and return it to the
position.
● Unplug your CD player
● If you are using a switched outlet to turn on and off your CD Player, you should
leave the Power Switch in the
unit, it will power up in fully active mode.
■ Connections
1. Analog Outputs(unbalance).
A pair of standard RCA jacks supplies an analog output signal from the CD Player
to the source inputs of an audio amplifier or other components. Using the audio cable,
connect the left channel output of the CD Player to the left channel source input on
the amplifier, and then, connect the right channel output of the CD Player to the right
channel source input on the amplifier.
2. Analog Outputs(balance).
A pair of XLR jacks supplies an analog balance output signal from the CD Player
to the source inputs of an audio amplifier or other component. Using the balance
cable, connect the left channel balance output of the CD Player to the left channel
balance source input on the amplifier, and then, connect the right channel balance
output of the CD Player to the right channel balance source input on the amplifier.
3.Digital Output
3-1.AES
EBU Output
/
Using a 110 ohm balance cable connect the AES/EBU output jack of the
CD Player to the AES/EBU input jack of the D/A decoder.
if it will be not used in a long time
" "
on
position. When AC Power is applied to the
"
out
.
"
4