Dust Free BIO-FIGHTER Ultra-Flex 1S Manuel d'installation et d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Dust Free BIO-FIGHTER Ultra-Flex 1S. Dust Free BIO-FIGHTER Ultra-Flex 1S 7 pages. Ultraviolet light systems

Imprimer la page

BIO-FIGHTER® ULTRA-FLEX INSTALLATION & OPERATION MANUAL

INSTALLING THE AHU VIEWPORT(s)

The Ultra-Flex comes with UV-C safe viewports

that must be installed separately. To install the

viewport, select a location near the lamp

installation and drill a 1/2" hole in the duct.

Then press the viewport into the hole.

CONNECT POWER AND CHECK OPERATION

Connect the device to 120V-240V power.

(Fig.8)

The device power switch must be turned on

and device checked for operation using the

viewport(s). The lamp(s) should be radiating a

bright blue light.

Power Cord

Connect black and

white wires to

120V-240V power.

Fig. 8 Power cord connection.

OPERATION

Under normal conditions the Bio-Fighter®

Ultra-Flex should be operated continuously to

extend the life of the lamp(s), and to increase

the effectiveness in disinfecting the location

selected. A convenient power switch is located

on the device, and should be turned off before

any maintenance on the device or HVAC sys-

tem is performed.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.

TROUBLESHOOTING

Maintenance and troubleshooting should be

performed by a qualified technician.

Device fails to operate.

1. Check that device is connected to proper

2. Check that fuse is in good working order.

3. Check that ballast is receiving correct

4. Check continuity of lamp filaments.

5. Check that wires are properly connected to

6. Check that lamp is properly connected to

Connect green wire

FUSE REPLACEMENT

to ground.

1. Turn off power to the equipment.

2. Unscrew the knob marked "Fuse" and

3. Install new fuse and screw knob back in

4. Turn on power to the equipment.

power.

Replace the fuse if necessary.

power. Replace ballast if necessary.

(Replace lamp if necessary.)

lamp and ballast.

lamp receptacle.

remove fuse.

place. Only use a 250V/3 amp fuse.