Elson EBW25 Manuel d'installation et d'utilisation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Elson EBW25. Elson EBW25 17 pages. 2.5 litre boiling water dispenser
Imprimer la page
10.0 USER INSTRUCTIONS
10.1 Once installed the fi lling and the heating cycles of the Elson EBW25 are
completely automatic.
10.2 To dispense water, place a suitable container under the outlet spout and pull
the tap handle down and towards (or pushed away) the user. The water
dispensed will at all times be boiling or close to boiling point so due caution
must be taken when using the product.
10.3 The tap handle is spring loaded so that when released it will spring back to the
"off" position (no fl ow).
10.4 The Elson boiling water dispenser is fi tted with two neon indicators. The upper
red LED indicates POWER ON. The lower LED indicates TEMPERATURE
READY. When the LED is fl ashing, the unit is commissioning (DO NOT DRAW
OFF WATER). When the LED is continuously on, the unit is ready to be used.
10.5 If the store of hot water is completely withdrawn, the fl ow rate from the outlet
tap will reduce to the fi lling rate of the heater (leave for 2 minutes before
drawing any more water off). This slow fl ow rate allows the incoming water to
be instantly reheated, it does not indicate a fault with the water heater.
10.6 If the unit is not used for a few days the water may become "stale". In
these instances it is advisable to draw off the contents and discard the water
at least twice to remove the "stale" water. This will ensure that "freshly" boiled
water is used to make your drinks etc.
10.7 Similarly, if left unused it is possible that some scale residue will collect in the
outlet tap. This will cause the outlet water to appear "milky" for a short while.
If this condition occurs it is recommended that the fi rst few cups are drawn off
and discarded.
14