CB-tec neocube-o Manuel d'utilisation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CB-tec neocube-o. CB-tec neocube-o 20 pages.

Imprimer la page

2.1 INSTALLATION MANUAL FOR LIQUEFIED PETROLEUM GAS

1. Connect the pressure regulator to the gas cylinder (left-handed thread) (the maximum allowable filling amount is 10.5 kg).

To do so, use suitable (adjustable) pliers. It is not enough to tighten it by hand; This could allow a leak to occur. Replace the gas

cylinder only in well-ventilated areas and not near candles, cigarettes or other flammable sources.

2. Caution: Before connecting the pressure regulator, always ensure that the rubber gasket is present and undamaged. If not,

the device must not be used until the gasket is replaced.

3. Make sure that the gas cylinder is always standing upright. The gas hose must not come into contact with sharp objects or

edges which could damage the inner tube. Be sure that the gas hose does not come into contact with hot parts of the burner.

4. Check all of the connections for leaks. To do so, moisten all of the gas connections with soapy water or use a gas leak detection

spray. If bubbles arise in the suds or the gas leak detection spray, there is a leak.

5. Place the supplied lava stones (8-16 mm) in the shape of a small pile (Fig. 1 b) or a bank (Fig. 1 C) on the writer rim well.

Be sure that no small pieces of stone enter the burner. Also be sure that no stones are lying on the thermal element.

The fireplace is now ready for use.

Warning: Check the gas hose at least once a month as well

as each time you change the gas cylinder. If the hose shows

signs of cracks or other damage, it should be replaced by a

tube of the same length and quality.

2.2 INSTALLATION INSTRUCTIONS FOR NATURAL GAS

1. Secure the gas stove in such a way that it cannot be moved once the gas pipe has been connected up.

2. The gas pipe must be installed by a recognised specialist installer in accordance with all applicable and/or local standards

and provisions.

3. Spread the lava stones supplied with the stove (approx. 0.9 kg - 8-16 mm) over the fire bed in the form of a small heap.

Ensure that no small stone chips enter the burner. Ensure that there are no stones on the thermocouple.

4. Check all of the connections for leaks. Coat all gas connections with soap lye or use a gas leak detector spray.

If bubbles arise in the suds or the gas leak detection spray, there is a leak.

5. The stove is now ready to use.

3. TECHNICAL DATA

Manufacturer

Contact details

Model

Versions

Country of destination

Standard

PIN Number

Propane connection

Heat output

Manufactured by CB-tec GmbH

CE 0085 | CS 0052

CB-tec GmbH

Behaimweg 2, D-87781 Ungerhausen

Phone: +49 (0) 83 93-94 69-0

neocube-o

Propane, Butane

Germany (FRG)

EN 14543 + A1

CE 0085CS0052

Pressure regulator 50 mbar

6,5 - 9,0 kW

PIN: 0085CS0052

Fig. 1a

Fig. 1b

neocube-o | 13