CB2 ABUELO Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CB2 ABUELO. CB2 ABUELO 17 pages.

ATTACH THE SEAT POST AND SADDLE

Try to twist the saddle from side to side. If the saddle moves in relation to the bicycle frame you

will need to adjust (tighten) the seat post quick release a bit tighter. Tighten until the seat post

is securely clamped.

To tighten the quick release, open the quick release, hold the nut opposite the lever with one

hand and rotate the quick release lever clockwise a complete rotation while holding the nut

firmly. This will tighten the entire quick release mechanism. Now close the quick release lever.

You will notice that the quick release lever is more difficult to tighten.

If the quick release requires more tightening, unlock the quick release and continue to rotate

the quick release lever while holding the bolt opposite the lever until the quick release

mechanism is appropriately tightened. Repeat if necessary.

WARNING: Riding with an improperly tightened seat post can allow the saddle to

turn or move and cause you to lose control and fall.

ATTACH THE REFLECTORS

WARNING: Do not fail to install the reflectors on your bicycle. They are an

integral part of the bicycle's safety system.

Securely fasten the front white reflector to the bracket using the mounting screw. Securely

fasten the reflector bracket to the handlebar. If not already attached, attach the rear reflector to

the seat post. If your bike has fenders, your rear reflector may be integrated into your rear

fender. For bracket reflectors, adjust each reflector's angle so that it is at 90 degrees to the

ground.

If not already attached, attach the two amber wheel reflectors to a pair of adjoining spokes of

each wheel, in a position opposite the tire valve stem and as close to the wheel rim as the

mounting clips allow.

FINAL CHECK

While this bicycle has been pre-assembled, some loosening of components may have occurred

during shipping and handling. Before attempting to ride this bicycle, check all nuts, bolts and

other hardware and tighten if necessary.

Flip open the quick release to loosen the frame seatpost

clamp.

Insert the seat post into the frame. Make sure that the

seatpost is inserted below the "minimum insertion" mark

on the seatpost. Adjust the saddle to the desired height.

The seat post must be inserted so that the "minimum

insertion" line marked on the seat post is not visible.

Close the quick release to tighten the seat post clamp bolt.

WARNING: If your seat post projects from the

frame beyond the minimum insertion or

maximum extension mark the seat post may

break, which could cause you to lose control and fall

and result in serious injury or death.