CBC HSW-H30 Manuel d'installation et d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} CBC HSW-H30. CBC HSW-H30 14 pages. Height strip camera

Imprimer la page

VOLTAGE & MAX WATTAGE

Color Camera 95mA (Max) @ 12VDC

Warning: All cameras are powered by DC voltage.

If you are running DC voltage over a pair of wires,

be careful of polarity. A barrel plug connector

with flying leads is provided. The white/black wire

corresponds to the core of the connector, and should be

supplied with +12VDC voltage. The black wire corresponds

to the shell of the connector, and should be used as DC

ground.

DISASSEMBLY

6.1 Cover Removal

1. Remove the unit from its packaging. Cut open one end of

the plastic tubing covering the Height Strip. Leave the

window masks in place.

2. Using a No. 2 Cross Recessed screwdriver, remove all four

screws that secure the cover (see Figure 2). Remove

cover.

Use a 5.5mm or

7/32" nut driver

to remove or

install cameras.

Keyhole

Front-Mounted

Camera Position

Figure 3 Internal View Camera Postions

Remove Screws (x4)

Figure 2 Assembled Height Strip Camera

Cover

Camera

Front-Mounted

Bracket

Camera Position

Base

Side-mounted

camera position

Front-Mounted

Camera Position

Side-mounted

camera position

6.2 Camera Removal/Relocation, and

Installing Accessory Camera

1. Each Height Strip ships from the factory with a single

camera installed that looks through the viewing window

located at the 5-1/2 foot mark. Two other viewing

windows are provided at the 4-1/2 foot mark and 6-1/2

foot.

2. To relocate the existing camera, use a 5.5mm (or 7/32")

nut driver to remove the M3 nut that attaches the

camera bracket to the base (see Figure 4). Remove the

camera and bracket from the base.

3. When installing a new camera or relocating the existing

camera, always refer to the keyhole to ensure the camera

is not installed upside down. The circular part of the

keyhole should face the ground and the slot should face

the ceiling. Always install the camera above the desired

pem stud in the base.

4. Accessory cameras require the own power supply. Do not

double terminate the supplied power adapter.

5. Install all front-facing cameras before proceeding to the

next section.

6. To install a side-mounted camera, refer to the

"Installation – Side-Mounted Cameras" section.

Counter Sinks

M3 Nut

Flat Washer

Pen stud

for side-mounted

camera

Keyhole

Figure 4 Close up View Camera Position

Push here to

Camera Bracket

adust the

camera's viewing

angle

Pen Stud

for Side-mounted

Camera

Pen Stud for

Front-mounted

Camera