Datalogic POWERSCAN PBT7100 guide Manuel de référence rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} Datalogic POWERSCAN PBT7100 guide. Datalogic POWERSCAN PBT7100 guide 16 pages. Cordless imaging reader
Également pour Datalogic POWERSCAN PBT7100 guide : Manuel de référence rapide (20 pages)
Imprimer la page
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Class B Compliance Statement
The user is cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio or television technician for help.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits under Specific Absorption Rate
(SAR) tests for portable devices operating closer than 20 cm to nearby persons, set forth in an
uncontrolled environment. The reader has been demonstrated to meet these RF emissions safety
limits.
Canadian Notice
This equipment does not exceed the Class B limits for radio noise emissions as described in the
Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables
aux appareils numeriques de la classe B prescrites dans le Reglement sur le brouillage radioelectrique
edicte par le ministere des Communications du Canada.
Solids and Water Protection
The reader is rated as IEC 529-IP65. This nomenclature designates the degree of water and dust
resistance, indicating the imager is totally protected against dust and is protected against low pres-
sure jets of water from all directions - limited ingression permitted.
The Base Station is rated as IEC 529-IP54, indicating the unit is protected against dust, limited
ingress (no harmful deposit) and is protected against water sprayed from all directions - with limited
ingression permitted.
Power Supply
Models require either a Listed class II or class III with a Limited Power Source (LPS). For the safety certification to be
valid, class III input power sources must be IEC/EN60950-1 (EN 60335-series, EN 60065 or relevant)
approved.
Input: 100 - 240 VAC Output: 5.2 VDC
Max. Current: 2.4 A
Quick Reference Guide
Statement of Agency Compliance
Max. Power: 12.5 W
3