Datamax E Class Mark II Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Datamax E Class Mark II. Datamax E Class Mark II 2 pages. Datamax mark ii e-4205e: quick start

Imprimer la page

a) Push the Printhead Latch down

and raise the Printhead Carrier



Assembly.

Printhead

Carrier

Load Ribbon

(perform only if

equipped with the

optional

Thermal Transfer

feature)



Printer/User

Interface

b) Remove and load the Hubs:

Slide a Ribbon onto a Hub and

an Empty Core onto a Hub

Printhead

Empty Core

Latch

(Normal power-up)

Normal Mode

F1 Pauses/Un-pauses the printer.

Feeds one label and clears fault conditions.

To calibrate media: Press and hold the until one

complete label has been output then release.

Cancels the current batch of labels.

Press the Pause button to print the next

batch of labels (if any) in the print buffer.

c) Replace the Hubs so that the

ribbon flows as shown below:

Push in and lift

to remove the Hubs

Ribbon

 Note: Ensure the inked side of

the ribbon faces the media

and NOT the printhead.



With the printer 'On' and loaded with 4 inch wide media (and ribbon, if needed):

To print the Configuration Label:

Press the

To print the Print Test Label:

Press the

Printing

To print the Ethernet/Network Report Label:

Configuration

Press the

and Test Labels



Follow and perform the suggested maintenance as detailed in the Operator's

Manual.



For detailed information on the topics referred to in this guide consult the

Operator's Manual; for detailed information on custom programming see the

Class Series II Programmer's Manual (included on the Accessories CD-Rom).

Contacting Datamax-O'Neil...

Corporate Headquarters

Technical Support

Website: www.datamax-oneil.com

d) Route the ribbon through the printer, as shown below:

Wrap the end of the ribbon

around the Empty Core

and secure it in place

buttons simultaneously.

(407) 578-8007

(407) 523-5540