DUTSCHER ClearLine UVT-B-AR Instructions pour l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} DUTSCHER ClearLine UVT-B-AR. DUTSCHER ClearLine UVT-B-AR 17 pages.

Imprimer la page

4.3.

Setup.

If the moving table is used, unpack it carefully and assemble according to the

enclosed assembling scheme.

Place the unit upon stable surface. Ensure that the unit is placed on a solid, level

surface not less than 720x550 mm (1290x600 mm for UVT-S-AR model), which is

able to support its weight and the weight of equipment and materials inside, for

instance on the T-4 / T-4L table.

Connect the power cable to the socket on the rear side of the unit, position it with

easy access to the power switch and plug.

4.4.

Shelf setup. Refer to the instructions included with the shelf.

Operation

Note. For UVC/T-M-AR and UVT-B-AR boxes, check that the short power

cable (fig. 5/1) is connecting the fuse box and the controller top.

5.1.

Connect the power plug to a grounded power socket. Turn on the Power switch:

UVC/T-AR – no switch, the unit powers up automatically;

UVC/T-M-AR, UVT-B-AR – on the right side of the unit, behind the rear wall (fig. 5/3);

UVT-S-AR – on the left side of the unit, behind the rear wall (fig. 6/1).

5.2.

UV exposition of the working place.

Caution! The front protective screen must be closed while the open UV lamp is

5.2.1. Turn ON the switch 2 (fig. 2/2) on the control panel (fig. 3/1). This switches on the UV

recirculator inside the unit (fig. 3/2) and the open UV-lamp exposition timer. The UV

recirculator will operate all the time until the switch 2 is turned OFF.

switched on. Otherwise, the operator can be exposed to a dangerous level

of UV emission.

Figure 2. Control panel