DUUN PT280 Manuel d'instruction - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DUUN PT280. DUUN PT280 18 pages.

Rotating shaft

Before connecting the power transmission shaft, ensure the following points.

Make sure that the shaft's protective tubes are intact and that the two halves of the shaft fit freely

into each other. The length of the power transmission shafts must be adjusted carefully, if it is too

long it can damage the bearing in the tractor's PTO or the propeller's bearings. Also ensure good

lubrication of the profile tubes. Read the instruction manual for the power transmission shaft.

Check that the PTO shaft can be rotated by hand to ensure it is not buckling anywhere.

Make sure, all covers for the shaft are in good condition and correctly fitted. Never start the

machine without this being in order! Pay particular attention to the plastic covers on the power

transmission shaft. If these are damaged, they must be replaced immediately! The locking chains

for the plastic covers must always be attached to suitable fasteners on the propeller to prevent the

covers from rotating. The covers are lubricated according to the specified interval.

Mount the PTO shaft on the tractor's PTO with the shear bolt coupling against the propeller

agitator. Safety chain is attached to the propeller to prevent rotation of protective covers.The

power transmission shaft must always have a shear bolt coupling max. 4180 nm. Check that the

power transmission shaft will not sit in tension when the machine is lifted to a maximum. or min.

height. Also note that the angle of the shaft can be too large when using very short shafts -

contact the supplier - importer.