Datapath X4 Manuel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Datapath X4. Datapath X4 2 pages. Stand alone display wall controller
Également pour Datapath X4 : Manuel de configuration (14 pages)
Imprimer la page
PACKING LIST
Your packing box contains the following items:
The x4 or x4-1U Display Wall Controller.
The x4-PSU Power supply unit with international
blades (x4 only).
Only use the x4-PSU power supply unit provided.
1 x Mains power cable (x4-1U only).
USB 2.0 cable Type A to Type B.
The latest drivers and Wall Designer application
software can be downloaded from:
www.datapath.co.uk.
HARDWARE INSTALLATION
Ensure the power supply for the DVI source is disconnected.
Connect the cable from the DVI source to the input socket
on the rear of the x4.
Connect the four displays to the output sockets on the rear
panel of the x4.
Connect the x4-PSU to the x4 and switch on the power
supply at the mains socket using the correct international
blade.
Power up the DVI source.
The Power LED located on the front panel will illuminate
to indicate that power has successfully been applied to the
unit.
The x4 incorporates an internal processor that will
continuously monitor the received DVI signal, and
whenever a valid and stable input is detected the Input LED
is illuminated.
If the Input LED is not illuminated, the x4 cannot detect a
valid DVI input source.
During operation, the x4 is able to adjust its internal
operation to maintain the programmed output proportions
even when the input resolution changes.
For detailed information on setting up the x4 please consult
the User Manual which is located in the Datapath
Documents folder in via the Start menu.
SOFTWARE INSTALLATION
Note: Do not plug the x4 into a USB port until the
software installation is complete.
Download the Wall Designer Software Application from
the Support pages on the Datapath website and follow
the Installation Wizard instructions as prompted.
The Datapath x4 can now be connected to a suitable USB
1.0 or 2.0 port using the cable supplied. At this point the
hardware will be detected by Windows® as an x4
splitter, and a New Hardware wizard is displayed. Allow
the wizard to search, and click on the recommended
option to enable the previously installed driver to be
associated with the new hardware.
Press Continue Anyway to accept the driver.
We suggest that you regularly visit the Datapath web
site (www.datapath.co.uk) for information on updated
drivers.
It is strongly recommended that you read the User
Manual prior to installation.