2easy DT-597 Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 2easy DT-597. 2easy DT-597 13 pages. Door station 2-wire series
Imprimer la page
Electric Lock Connection
Up to 2 Electric or Magnetic locks can be connected and open independently.
NOTE: both locks must be the same type, i.e.
2 x 'Power-on-to-unlock' or 2 x 'Power-off-to-unlock'
Lock/s can be powered from door station if:
1. Electric lock is 'Power-on-to-unlock'
2. The lock is 12V, and holding current is less than 250mA
NOTE: Exit Button is not timed
The 'Unlock Mode' parameter would be 0 (default, no need extra programming)
Connect one Lock
1 2 3
Connect one lock
Jumper position in
BUS
PL
EB
*
Automated Gates and Magnetic Locks
1. Connect low voltage box of the gates according diagram below
2. Additional power supply for Magnetic lock/s according lock specs
The 'Unlock Mode' parameter for 'Power-on-to-unlock' would be 0 (default, no need extra
programming)
The 'Unlock Mode' parameter for 'Power-off-to-unlock' would be 1 (needs extra
programming via monitor 'Installer Setup')
-7-
2-3
S1+
S2+
S-
LOCK
Connect two Locks
1 2 3
Connect two locks
Jumper position in
2-3
BUS
PL
S1+
EB
2
*
nd
EB
1
ST
*
S2+
S-
2
nd
LOCK
1
ST
LOCK