Dataplot EMBLEM EASY Airpress standard Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dataplot EMBLEM EASY Airpress standard. Dataplot EMBLEM EASY Airpress standard 20 pages. Pneumatic eyepress

Imprimer la page

5. Adjustments

5.1 Warnings About The Adjustments

Parts that should be replaced on a regular basis due to normal where are the

cutting or bottom die "E" and setting on top die "D". We will see that the parts

need to be replaced when either the cutting or the setting is not accurate. We

always recommend having a spare set of these parts on your stock.

When making adjustments if by any reason it is necessary to remove

parts meant for operator safety (cover, stainless steel plate ...) remember

to put them back where they belong and fasten them firmly.

WARNING: Shut the general air inlet valve "F" (see Fig. 1) to change dies,

make adjustments, install optional equipment or any other handling.

5.2 Dies Changing For Same Dimension Eyelet – Washer

The machine EMBLEM EASY AIRPRESS Standard sets eyelets sets on

different materials and thicknesses in a range of ,03 - 1,2mm.

However, although it works with different types of materials, it will not require

any adjustments (neither cutting or setting); just follow the guidelines on this

section to install properly the dies avoiding breakage of the cutting area.

WARNING: To change the setting dies it will be necessary at some point to connect

the air hosepipe to the compressor and open the air inlet valve "F" (see Fig. 1).

5.3 Guidelines to install the cutting and setting dies:

This machine is mainly composed of two vertical shafts on the front; on top is the shaft that

holds the setting or top die "D" and the bottom the shaft holding the cutting or bottom die "E".

(E)

Fig. 10

Puncher

(D)

Page - 9 -