DataStor DataSafe 307100 Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DataStor DataSafe 307100. DataStor DataSafe 307100 2 pages. External 4-bay tower enclosure kit

Imprimer la page
Installing The Hard Disk
If you are not familiar with the location of ALL the listed items,
refer to hard disk user's guide / manufacturer before continuing.
Note: Remove any mounting screws that may be on the drive.
Then position the drive into one of the slots in the 4-Bay Tower
by
placing it in from the front as in Figure 4.
Installing The Cables
1) Power Cable: Locate the power connector (male) on the
drive and connect the power cable as in Figure 5.
The power cable should have 4 end connections; 1 for each
drive. If for some reason you do not have 4 connections,
They may be chained together incorrectly. To chain them
properly refer to Figure 5.
2) SCSI Cable: Locate the SCSI Cable and connect these in
order starting with the bottom drive as shown in Figure 5.
3) SCSI ID Cable: Because drives vary, refer to Figure 6 to
connect the SCSI properly.
Note: If the SCSI ID cable supplied is not compatible with
the drives jumper pin setup, you will need the universal
SCSI ID cable kit (DataStor PN: 089011).
Finishing The Installation
1) Check the drive to make sure it is properly in position. Now
replace the mounting screws and fasten the drive to the rack.
Note: If you are installing a 3.5" drive you will need 5.25"
conversion brackets (DataStor PN: 104437).
2) Starting from the back of the tower, slide the cover slowly
over the enclosure, being careful not to pinch any wires.
Notice there are metal flaps on the fron cover. Position these
flaps so they slide under the fron panel of the enclosure.
3) Check over the enclosure to make sure the cover is completely
on. Now replace the screws into the back panel to secure
the cover.
12601 Monarch Street
Garden Grove, CA 92841-3918
800-777-6621 Fax: 949-833-9600
Copyright 2000 by DataStor, Inc. All rights reserved. No part of this document may be reproduced in any form without prior written consent
from DataStor. The information and specifications in this document are subject to change without notice. Changes to this document
are incorporated in new versions.
DataStor, and the DataStor logo are reqistered trademarks of DataStor, Inc. Other trademarks used herein are the property of their respective
owners. This document was printed in the United States Of America.
Installation Guide - 4-Bay SCSI Tower Installation Kit - VERSION 2 - Rev 1.0 - March 2000 - 307100 - Page 1 of 2
Figure 4
NOTE: Insert drive from front of
enclosure
Figure 5
Power Cable
Back Of Drive
Figure 6
SCSI ID
Switch plug
3-pin 2mm
Red
=
Ground
Orange =
8-Signal
Yellow =
4-Signal
Green
=
2-Signal
Blue =
1-Signal
SCSI Cable
Back Of Drive
Internal SCSI ID
Cabling
Ground 2mm
8-signal 2mm
Ground .1"
8-signal .1"
3-pin .1"