Datatool DT202 Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Datatool DT202. Datatool DT202 14 pages.

Imprimer la page

Lithium Battery

Measured Voltage

Greater or equal to 13.2 V

Between 13.2V and 12.4 V

Less than or equal to 12.4 V

Voltages are approximate

If the movement sensor is disabled, either by use of Transport Mode or via programming

then the status LED will flash twice in quick succession to indicate that the movement sensor

has been disabled, if the movement has been permanently disabled via programming the

indicators flash three times on arming and if arm/disarm tones are enabled, three chirps will

be heard.

Optional Supplementary Siren Output

The DT202 allows for the addition of an optional second siren using the Optional

Supplementary Siren Output, if used with a suitable siren this can increase the output volume

when the alarm is sounding.

Alternatively, the output can be connected to a pager input, allowing a notification to be

received on your pager device in the event of an alarm trigger occurring.

If you would like to use the Optional Supplementary Siren output feature speak to your

installing dealer.

Optional Secondary Trigger

The Optional Secondary Trigger allows the motorcycle or its accessories to be protected in

the following ways listed below, it may only be possible to use one of the methods listed below

at a time and some options may not be available on certain models of motorcycle.

•

Closed Loop – This allows a loop of wire to pass around an accessory or luggage

attached to the motorcycle. Should the cable be cut to remove the accessory or

luggage with the alarm in an armed condition the alarm will trigger.

Please note the cable should be fully in place and the connected before arming the

alarm.

•

Additional Locker Protection – Additional magnetic reed switches can be added to

protect a seat, panel or storage compartment, if installed an alarm trigger will occur if

a seat, panel or storage compartment be open or removed that has a switch installed.

•

Please note all protected seat, panel and storage compartments should be fully in

position or closed before arming the alarm system.

•

Side Stand – If connected the alarm will monitor the state of the side stand when

armed, if the position of the side stand is changed during the armed period of the

alarm system the alarm will trigger.

Please note it is recommended that if using the side stand as a secondary trigger the

motorcycle is left on side stand and not the main stand for maximum protection.

If you would like to use the Optional Secondary Trigger speak to your installing dealer.

Scorpion House, Drumhead Road, Chorley North Business Park, Chorley, Lancashire, England. PR6 7DE

Tel: +44 (0) 1257 249928 E mail:

LED Sequence

Once every 5 seconds

Once every 10 seconds

Once every 20 seconds

Datatool is a brand of Scorpion Automotive Ltd

[email protected]

DT202 Operation Guide Revision 1 24-07-2023

Indicative Status

Fully charged battery

Partially discharged battery

Low battery

Web: http://www.datatool.co.uk