Aussie Pumps RAPTOR EXTREME Series Manuel d'instruction de l'opérateur de sécurité - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction de l'opérateur de sécurité pour {nom_de_la_catégorie} Aussie Pumps RAPTOR EXTREME Series. Aussie Pumps RAPTOR EXTREME Series 16 pages. Mine boss hydro-blasters

Imprimer la page
August 2019
AUSSIE GRIT BLAST INSTRUCTIONS (optional accessory)
WARNING: To reduce the risk of injury, always
protect eyes and face with safety glasses and
mask, and hands and arms with heavy work
gloves when spraying abrasive materials.
1.
Fit grit blast gun/lance kit at end of high pressure
hose, in place of normal gun/lance assembly.
2.
Lodge sand probe into sand bag. Note the sand
must be dry.
3.
Connect and open the water supply line to the
blaster before starting the pressure washer.
4.
Squeeze the gun trigger to bleed air as normal
keeping the tip of the gun pointing down.
5.
Turn on the pressure washer and squeeze the gun
trigger
to
CAUTION: Always test spray on a scrap of similar
material first! The high pressure spray could
damage the surface if the grit blaster is held too
close.
6.
To determine best distance for grit blasting, start
with the spray nozzle a metre away from the
surface and gradually move closer, frequently
checking the surface for damage.
7.
Always point the nozzle downward when not
spraying. This prevents water from entering the
sand supply. If water does get into the sand
supply hose, remove the probe from the sand,
hold the gun trigger open, and let the hose air
dry. Always be sure the sand hose is dry before
using.
8.
Keep the sand covered to prevent the overspray
from wetting the sand. Do not allow small pieces
of the sand bag to fall into the
sand supply as they could
prevent the flow of sand.
Head locking nut
holder
ceramic piston with dimple
WORK SMART ... STAY SAFE
AUSSIE SAFE BLASTING
activate
the
spray.
| Aussie Raptor (Class B)... Operator's Instruction Manual
GRIT BLAST HEAD SET UP INSTRUCTIONS
1.
Unwind the tail coupling and remove top of the
blast head. Screw in the nozzle to the tail.
2.
Replace the tail and ensure
that the tip of the nozzle is a
minimum of 28mm from
leading edge of body and a
maximum of 36mm. The fan
spray from the nozzle should
be perpendicular to the sand
intake tail. Mark the top side
of the hexagonal coupling
for reference.
3.
Line up the dimple in the
ceramic
nozzle
with the sand intake tail and
hold in place with the
holder. Screw down the
head locking nut.
4.
The fan produced by the two nozzles must be
aligned.
5.
Connect grit blast head to hp gun/lance and
activate the gun with the high pressure blaster
running. Check the fan jet leaving the nozzle is
the full width of the slot. Adjust by rotating
hexagonal tail coupling, ensuring that the marked
side of the tail always finishes on top.
6.
With the high pressure washer turned off,
connect the sand hose to the sand intake tail and
secure with hose clips.
Sand intake tail
Aussie Pumps
Check angle of jet from
nozzle
Min 28mm
perfectly
9