AUSSIE TONNEAU ATB01030 Manuel d'instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} AUSSIE TONNEAU ATB01030. AUSSIE TONNEAU ATB01030 6 pages. Ford ranger px single cab with headboard
Imprimer la page
8. Using the Bar Bracket as a guide, drill into the body. Apply rust inhibitor and rivet the front and rear
holes to complete attachment of the Bar Bracket. Repeat for the passenger side of vehicle.
9. Measure 465mm up from the bottom edge of the tail gate and 25mm, 295mm & 562mm in from
the outside edge of the driver's side of the tailgate and mark button positions. See Figure 5
10. Repeat for the passenger side of vehicle. Drill holes then apply rust inhibitor and rivet buttons into
place.
11. Measure down 165mm from the inside edge of the tub,
and back 35mm from the front outside edge of the tub and
mark. This is the position of the front button. See Figure6
12. Measure down 155mm from the inside edge of the tub,
and forward 10mm from the front outside edge of the
tailight and mark. See Figure 7
13. Using a straight edge or string line, draw a line between
front mark & rear mark as shown in Figure 8
14. Fit the front button only to the vehicle by drilling a 4mm
hole at the front mark then apply rust inhibitor and rivet
button into place.
Repeat steps 11 to 14 for passenger side.
Figure 5
Figure 6
Figure 7
Figure 8