Datavideo DAC-2 Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Datavideo DAC-2. Datavideo DAC-2 13 pages. Important note to make dac-2/dac-100 work with pinnacle dv500
Également pour Datavideo DAC-2 : Manuel d'installation rapide (6 pages), Manuel complémentaire (5 pages), Manuel complémentaire (13 pages)

Imprimer la page

TYPICAL INSTALLATION

Now you can import your analog video into your PC in DV formats! The DAC-2 converts

the analog video and audio signals into DV formats so that you can use your computer to

edit your video. When you are finished, simply send the DV files back through the DAC-2,

where they are converted to analog signals and then can be recorded onto tape.

Operation Procedure:

1. Install the equipment as shown in the installation diagrams below.

2. Make sure all of your equipment is turned on.

3. Select the video input source DV or A/V analog signal.

4. In A/V analog input mode, select the desired audio sampling frequency 32K, or 48KHz.

5. Playback the source video.

Note: You can't get a Component (YUV) and S (Y/C) signal at the same time. To achieve Component

(YUV) video output with DV input, disconnect the "S" plug from S jack. To enable the S (Y/C)

signal from the DV input, simply plug in S connector and disconnect the Component (YUV)

cables.

Use your DV Camcorder to record your existing videos onto a DV Tape. Most DV Camcorders

cannot accept analog video recording.