Datavideo DAC-2 Manuel complémentaire

Parcourez en ligne ou téléchargez le pdf Manuel complémentaire pour {nom_de_la_catégorie} Datavideo DAC-2. Datavideo DAC-2 5 pages. Important note to make dac-2/dac-100 work with pinnacle dv500
Également pour Datavideo DAC-2 : Manuel d'installation rapide (6 pages), Manuel d'installation (13 pages), Manuel complémentaire (13 pages)

Imprimer la page

Configuring a NTSC DAC-2 with Avid DV Xpress 3 on Windows 2000

Button Functions

DV Input

The DV Button, has two functions:

Select/Reset

It selects DV as the input source and is also a reset.

Resetting the DAC-2 will put it into its default setting based on its Firmware version.

Composite

This button is for analog input source selection: Composite video (RCA), S-Video

Video, S-

(Y/C), and Y.U.V. (Component)

Video, Y.U.V.

12/16 bit

The A Encode button has two important functions; it selects the encoding audio

Audio/Mode

frequency between 12 bit (32 KHz) or 16 bit (48 KHz) and if it is held down for 3

Selection

seconds it switches modes.

1. Verify which EPROM is in the DAC-2.

On the underside of the DAC-2 there is a serial number sticker, which has a version number on it, the

version number is stamped or on a sticker.

Please find your version number in the table below:

2. Datavideo NTSC DAC-2 Firmware Table

Firmware Version

4.7

4.8

5.2

5.3 or Higher

If you want a different chip contact Datavideo USA, (562) 696-2324, [email protected].

Preset / Default Mode

Mac/Windows XP

Windows 2000

Mac/Windows XP

Details

Preset Mac/Windows XP

Refer to 4.8/5.2 Instructions

Preset Mac/Windows XP