Agri-Fab 45-0354 Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Agri-Fab 45-0354. Agri-Fab 45-0354 8 pages. Grader blade

Imprimer la page

4. Attach the mast support to the hole in the mast

assembly just in front of the threaded stud. Use a

1/2" x 4" hex bolt and 1/2" Nylock hex nut installed

so that the nut is on the bottom side of the mast

assembly. Do not tighten yet. See figure 4.

MAST

SUPPORT

MAST

ASSEMBLY

1/2" NYLOCK

HEX NUT

FIGURE 4

5. Attach two mast braces to the sides of the mast

assembly using a 1/2" x 3-1/2" hex bolt and 1/2"

Nylock hex nut. Use the end of each brace with the

smallest hole. Do not tighten yet. See figure 5.

MAST BRACE

(LARGE HOLE)

1/2" NYLOCK

HEX NUT

FIGURE 5

1/2" x 4"

HEX BOLT

1/2" x 3-1/2"

MAST

HEX BOLT

BRACE

(SMALL

HOLE)

6. Attach two mast sides to the mast support using a

1/2" x 3-1/2" hex bolt and 1/2" Nylock hex nut. Use

the end of the mast side with two holes, inserting

the hex bolt through the smaller hole. Do not

tighten yet. See figure 6.

USE THIS HOLE

1/2" x 3-1/2"

HEX BOLT

MAST

SIDE

FIGURE 6

7. Connect the lower end of each mast side and the

front end of the each mast brace to the ends of the

mast assembly's cross brace using two category 1

pins, two 7/8" lock washers, and two 7/8" hex nuts.

See figure 7.

Be sure the threaded end of each category 1 pin is

toward the center of the grader frame so that the

threaded ends face each other. Securely tighten

the hex nuts against the lock washers. Tighten all

previously installed mast hardware.

7/8" LOCK

WASHER

7/8" HEX

N U T