Dato LJCC2040A Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dato LJCC2040A. Dato LJCC2040A 18 pages. Two post lift

3.2.3 INSTALLATION DRAWING OF POST

Notice: Drill hole withφ19mm aiguille and then anchor with pneumatic tools. The depth of hole and bolts

should be the same and insert the bolt. The air anchor, made against the washer to under the post. When

fastening to the use of torque wrench, do not use impact tools to tighten.

3.2.4 STEEL CALBE INSTALLATION

1 Fix the posts according to the drawing, and place the main

post, slave post according to picture 4. Drill hole for expansion

bolt withφ19mm aiguille and no need to fix the bolt at the

moment.

2 Check and ensure the posts dimension is in accordance with

picture 5. Test the vertical of post with spirit level (construction

using type).

3.2.5 ORIENTATION OF CROSSBEAM

1 Fix the crossbeam according to the drawing. That side

with limit switch should be installed on the post with

hydraulic unit, then fasten with screw.

2 Fasten the expansion bolt.

Notice: Select suitable steel shim as gasket and insert under the

post bottom, to make the post vertical. The thickness of steel shim

should less than 5 mm.

Oil pipe and accessory installation

3.2.6

1 Connect the oil pipe and cable through the oil pipe slot.

2 Fix the hydraulic station, then connect the oil

pipe fittings and wire plug.

Picture 6（oil pipe list and installation）

user's manual

Picture 4 (post installation)

Picture 5 (post orientation)

Chapter 3 Installation