Agri-Fab 501885A Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} Agri-Fab 501885A. Agri-Fab 501885A 2 pages.

Model 501885A / 502492A Assembly Instructions

Step Five

1) Flip cart over so it rests on the wheels

2) Assemble front tongue on top of rear tongue using

three 3/8" x 3" hex bolts and 3/8"

Hint: Ease assembly by supporting the rear

a block of wood.

Step Seven

1) Assemble the elbow to the impeller housing using four

5/16" x 3/4" self tapping hex bolts and four nylon washers.

Push while turning to help start the bolts into the unthread-

ed holes.

the hose adapter (nozzle)

to the front of the impeller housing

actuator bracket contacts the housing switch.

4) Place a hose clamp onto the end of the hose and push it

onto the hose adapter (nozzle). Tighten hose clamp onto

hose and hose adapter but do not collapse hose adapter.

Step Six

1) Attach the engine/impeller housing assembly to the

upper holes in the angles welded to the tongue. Use four

5/16" x 3/4" hex bolts, 5/16"

nuts.

2) To center the elbow with the opening in the hard top:

a. Push the vinyl boot back inside the opening

b. Loosen the bolts tightened in step six by

c. Push against the elbow to center it with the sides of

d. Retighten the four bolts that you loosened

Step Eight (not shown)

1) Place the hose hanger rod assembly into the hose

hanger bracket on the impeller housing assembly.

2) Loop the 25" tarp strap under the hose. Fasten the

hooks to the hose hanger rod assembly.

Step Nine (for Chip-n-Vac model only)

Hint: Tip the cart bed back for easier access in this step.

1) Attach the chipper chute assembly to the weld bolts on

the back side of the impeller housing using three 5/16" flat

washers and 5/16" Nylock nuts. Tighten.

2) Insert the tamper plug into the end of the chipper chute

assembly.

the switch

washers and 5/16" nylock

approximately ¼ turn each

the opening

Form 48708