Brenell Mark 610M Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Brenell Mark 610M. Brenell Mark 610M 10 pages.

Imprimer la page

To adjust, hold lower milled edge and then turn upper edge in an anti-

clockwise (unscrewing) direction. You will then have

twp

sections

which may be relocked at the height necessary to feed the tape centrally

the.

take-up reel, by holding the lower section and screwing the upper

section hard against it.

Deck Switches

The two

large knobs control the Fast Wind, Fast Rewind, Record and

Replay functions of the tape deck whi 1st the small knob is used for the

selection of the tape speed.

Speed Changing

The switch provided has three positions but the tape speed wi II depend also

upon the size of capstan sleeve in use.

If the head covers are removed

(Plr

Fit) one may observe the brass capstan

sleeve to the right of the tape heads.

The sleeve is a tight fit over the spindle and is retained in position by means

of a grub screw (see side of capstan sleeve).

Two sleeves are provided with each recorder normally the larger sleeve is

fitted and the smaller sleeve is stowed inthe pocket in the top of the cabinet.

When the larger sleeve is used the three speeds, 38cms (15 i

p.s.), 19 ems

(7! i .p .s .) and 9.5 ems (31 i. p .s.) may be selected by means of the speed

change switch (see switch positions marked 38, 19, 9 .5) whilst with the

smaller sleeve in use the speeds for each switch position wi

be halved (see

alternate markings 19, 9.5 and 4.75).

Note that the switch has but three positions and the knob cannot be turned

more than 60 degrees. Should a capstan sleeve be changed, ensure that

there is a clearance of approximately 1/16th inch between the bottom of the

sleeve and the top of the bearing which protrudes through the deck plate.

'·

Revolution Counter

•

digital revolution counter is fitted - pressing the button to the right of

the·

counter resets

all

digits .to zero.

Pause Control

lever to

enable.

the tape movement to be stopped. fvA.ove to extreme right

hand side to lock control. Do not use this control when winding or rewinding

the tape.

,lv\ains Supply Switch

13-2

The mains supply to both the Deck and Amplifier is switched by means of the

extreme right-hand button on the amplifier panel .

This switch is of the push-push type, i.e. push for on or off.

It is suggested that after loading the machine with tape, the operator should

familiarise himself with the deck functions {not necessarily changing the

capstan sleeve at this juncture.).