Agri-Fab SUPER 17 Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Agri-Fab SUPER 17. Agri-Fab SUPER 17 12 pages. Atv cart
Également pour Agri-Fab SUPER 17 : Manuel du propriétaire (12 pages)
Imprimer la page
9. Assemble the front panel over the end of the cart
using six 1/4" x 3/4" hex bolts and 1/4" nylock nuts
as shown in figure 4. Leave two holes in the
bottom of the panel empty as shown. With the cart
body halves pulled together, tighten the bolts in
the bottom of the front panel, then tighten the
bolts in the sides. See figure 4.
10. At this time tighten the bolts assembled in step 4,
which fasten the bottom of the cart together.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" NYLOCK NUT
FIGURE 4
11. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" nylock nuts
as shown in figure 5. Heads of bolts go on the
inside of the cart. Tighten.
WHEEL
SUPPORT
5/16" NYLOCK
NUT
FIGURE 5
1/4" x 3/4"
HEX BOLTS
1/4" NYLOCK NUT
5/16" x 3/4"
TRUSS HEAD BOLT
5
12. Turn the latch stand bracket so that the aligning
tab is at the rear (bottom) of the bracket. As-
semble the latch stand bracket to the cart using
four 1/4" x 3/4" hex bolts and 1/4" nylock nuts.
TIGHTEN. See figure 6.
LATCH STAND BRACKET
ALIGNING TAB
AT BOTTOM
1/4" NYLOCK NUT
FIGURE 6
13. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 3/4" hex bolts and 1/4"
nylock nuts. Also assemble two 1/4" x 3/4" hex bolts
and 1/4" nylock nuts to the two rear corners of the
cart. Tighten. See figure 7.
CORNER CAP
1/4" x 3/4"
HEX BOLT
FIGURE 7
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK NUT