Agri-Fab SUPER 17 Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Agri-Fab SUPER 17. Agri-Fab SUPER 17 12 pages. Atv cart
Également pour Agri-Fab SUPER 17 : Manuel du propriétaire (12 pages)
Imprimer la page
14. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside down
on its top flanges, so that the wheel support is facing
up. See figure 8.
15. Assemble both axle extension brackets to the wheel
support using eight 5/16" x 3/4" hex bolts nad 5/16"
nylock nuts. See figure 8.
AXLE EXTENSION BRACKETS
5/16" NYLOCK NUT
5/16" x 3/4"
HEX BOLT
FIGURE 8
16. Place the tongue, open side facing up, onto the wheel
support and the latch stand bracket. See figure 9.
17. Place a long spacer tube on each side of the tongue and
assemble the axle through the axle extension brackets,
the two spacer tubes and the tongue. See figure 9.
LONG SPACER TUBES
AXLE EXTENSION
BRACKET
FIGURE 9
18. Place the latch lock lever through the slot in the tongue
WHEEL
SUPPORT
FIGURE 10
19. Hook the short end of the spring into the hole in the
AXLE
TONGUE
LATCH STAND
BRACKET
FIGURE 11
6
as shown in figure 10. Assemble the 5/16" x 3-3/4" hex
bolt through the tongue, the lever and two 5/16" hex
nuts (SEMS) (one on each side of the lever). Assemble
a 5/16" nylock nut onto the end of the bolt so that the
bolt has no end play, but can rotate freely. Tighten the
two 5/16" hex nuts (SEMS) against the sides of the latch
lock lever so that the lever is centered in the slot. See
figure 10.
5/16" HEX NUTS (SEMS)
5/16" x 3-3/4"
HEX BOLT
latch lock lever. Use the spring puller tool to hook the
long end of the spring into the square hole in the tongue.
The spring puller tool can be stored when finished. See
figure 11.
SPRING PULLER TOOL
LATCH
LOCK
LEVER
5/16"
NYLOCK
NUT
LONG END
OF SPRING
LATCH LOCK LEVER