Cookshack Fast Eddy PG1000 Manuel de l'opérateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cookshack Fast Eddy PG1000. Cookshack Fast Eddy PG1000 11 pages. Pellet cooker

Imprimer la page

 Slide the chimney through the hole on the shelf and secure it to the side of the

grill using the nuts and screws supplied.

 Install the chimney cap into the threaded fitting on the chimney leaving 1 ½

inches between the flue and the bottom of the cap and tighten the lock nut to

secure.

 Insure the fire diffuser is in place over the fire pot.

 Insure the drip tray is in the proper position under the indirect cooking grill.

 Place the drain bucket on the retaining clip under the drain tube.

 Place both grills in their proper position and fallow the operating instructions

listed below.

OPERATING INSTRUCTIONS

 During first firing turn switch on and set the temp to 400 degrees. The ignitor will

stay on until the cooker gets to 140 degrees. It will take several minutes to get

pellets to drop into the fire pot.

 Leave lid open during igniting. Close when you see flames from the fire pot.

 Manual lighting instructions (in the event there should be a failure with the auto

igniter.) Pour ½ cup pellets into the fire pot. Squirt approximately 2 tablespoons

of alcohol gel into the fire pot and ignite with a match. Never attempt to squirt

alcohol gel onto burning embers to further ignite. This has the potential of serious

injury. Let this burn for 4-5 minutes, turn on the switch and set the thermostat to

300 degrees.

 Your grill has an "LHt" and an "HHt" adjustment that allows you to make some

adjustment to the ON time the auger runs when above or below temp. This allows

you to fine tune the operation of the grill. These are set at a standard setting from

the factory and we recommend getting use to your grill before making

adjustments.

 Press and hold UP+DOWN for 5 seconds, display says "LHt". This is the "Low

Heat Time". This is the ON time when the temperature is above set point.

Release UP+DOWN to edit the value. Default is 3.5 sec.

 Press and hold UP+DOWN for 5 seconds, display says "LHt". CONTINUE

HOLDING UP+DOWN FOR ANOTHER 5 SECONDS, display says "HHt".

Fast Eddy's Model PG1000