CookTek MagnaWave MC2500 Manuel du propriétaire et instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et instructions d'installation pour {nom_de_la_catégorie} CookTek MagnaWave MC2500. CookTek MagnaWave MC2500 6 pages. Cooktek magnawave cooktops
Également pour CookTek MagnaWave MC2500 : Manuel du propriétaire Installation et fonctionnement (11 pages), Manuel du propriétaire (10 pages), Manuel d'installation et d'utilisation (10 pages)

Imprimer la page

INSTALLATION OF DROP IN COOKTOPS

• When installing the drop-in Cooktop, use the dimensions provided in this

manual to trace the cutout dimensions onto the countertop.

• Be sure to allow for a minimum clearance of 2" between all sides of the

housing and any surface or obstacle, and 6" between the bottom of the housing

and any surface or obstacle.

• Cut out and drill holes as required in countertop.

• Drill holes for control box mounting.

• When installing the drop-in Cooktop , apply a bead of an NSF Standard 51

approved sealant (such as Dow Corning 732 Multi-Purpose Sealant or GE RTV

108) around all four edges of the countertop cutout. Carefully follow sealant

manufacturer's instructions to insure proper adhesion.

• Multi-Purpose Sealant or GE RTV 108) around all four edges of the countertop

cutout. Carefully follow sealant manufacturer's instructions to insure proper

adhesion.

• Locate Cooktop over countertop cutout. Pass control panel and cord through

cutout, then pass the base of the Cooktop through the hole until flange rests on

the countertop.

• Mount control panel using screws supplied. Mounting options are illustrated in

attached drawing.

• Plug Cooktop into a grounded 120V or 200-240V (depending on the model

purchased), single-phase receptacle. Check rating plate on the Cooktop to

verify correct voltage. NOTE: For proper operation, a dedicated circuit

should be used for each unit installed. Each circuit should be protected

with a 20 amp minimum circuit breaker.

UL RATED AND CE APPROVED FOR COMMERCIAL USE

CookTek's MagnaWave Cooktops have been tested in conformance with

Underwriter's Laboratories and bear the UL commercially rated approval.

CookTek's MagnaWave Cooktops have been tested in conformance with the

European Economic Area standards and bear the CE marking signifying European

Conformity.

*For Single Hob Units Only

COOKING BY POWER COOK (WATTAGE)*

General Operation:

When your application requires a high intense heat or you want a quick temperature

increase, the Power Cook mode should be used.

What to Do:

1. Turn the Cooktop "ON" by turning the control knob to the right.

2. Momentarily depress the Power Cook button.

3. Turn the control knob until the desired Power Cook setting (1-20) appears on the

LED Display.

4. Turn the control knob to the left to decrease power and to the right to increase

power.

5. To turn the Cooktop off, turn the control knob to the far left until it "clicks" and

the LED display no longer illuminates.

IMPORTANT: You can switch between SmarTemp and Power Cook at anytime

just by pressing the SmarTemp/Power Cook button.

IMPORTANT INFORMATION

• Never heat an empty pan, it may damage the Cooktop or cookware and over-

heat the unit. When overheating occurs, an error code will flash on the LED

display and the Cooktop will shut itself off automatically. When the tempera-

ture returns to normal, the Cooktop will start to cook again.

• Remember to turn the Cooktop off after each use.

• Keep the Cooktop away from gas and electric ranges or open flames. Do not

place in the oven. If the surrounding air temperature is too high, the Cooktop

will cease to function properly.

• Be sure to dry off the outside of the pan before use. Otherwise As If the pan

temperature rises, the water droplets on the outside of the pan may begin to

boil and spatter.

• Do not touch the ceramic plate (or the top of the Cooktop) immediately after

use. The heat from the pan will be transferred to the ceramic plate causing it to

be hot to the touch.

• Do not place any articles on the Cooktop other than inductive cookware. For

example, do not place cans on top of the Cooktop as they may explode.

• Do not use aluminum foil on top of the Cooktop.

• Do not use the Cooktop near a faucet, swimming pool, sink, lake, or other

areas where water can be found. Never store the Cooktop outside or upside

down.

• Do not obstruct, block, or alter the air entrance or outlet. Do not stick foreign

objects into these openings.

• Do not strike or damage the Cooktop. Do not put the Cooktop in your luggage.

Throwing or dropping the Cooktop can damage the internal components or

crack the Cooktop, voiding your Warranty. If the Cooktop becomes cracked,

unplug immediately and do not use.

CARE & CLEANING

Your CookTek Induction Cooktop is easy to keep clean. Be sure to follow these

easy instructions:

1. Turn the unit OFF and remove the plug from any power outlets prior to cleaning.

2. When the unit is cool, wipe the surface and body with a damp cloth. Use a mild

scouring agent on the stainless steel housing such as Bon Ami or Barkeeper's