Australian Pump Industries Clean Air Drum Vac Manuel - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Australian Pump Industries Clean Air Drum Vac. Australian Pump Industries Clean Air Drum Vac 4 pages. Industrial wet/dry
Imprimer la page1.5
In The Case Of An Emergency
▪
Pull out the mains connector plug.
▪
Immediately apply recognised first aid measures.
▪
Do not resume operation until machine has been checked by a qualified technician.
1.6
Electrical connection and supply
▪
240 volts.
1.7
Warning
▪
Do not collect dust that may contain asbestos material with this machine.
▪
The cleaner should never be used for picking up hot ashes, explosive fluids or undiluted acids
or solvents. These include petrol, paint thinner and heating oil, all of which can generate
explosive mixtures or vapours when mixed with the suction air. Acetone, undiluted acid and
solvent may damage the materials of the machine.
▪
For cleaning or servicing the machine or when replacing parts the motor should be switched
off and the electric plug be withdrawn from the socket.
▪
Care should be taken to ensure that the electric cable is not damaged by being driven over,
crushed or strained. Care should also be taken to ensure the electric cable is not pulled
through pools, water or spills.
▪
Check electric cable regularly for any signs of damage, ageing or fraying.
▪
The machine must not be used if the electric cable is not in a proper condition.
▪
It is advised when using equipment that earmuffs be used during operation of the unit.
▪
Do not hose down the vac head as water may enter the unit and damage the motors.
▪
When using your machine for wet use only ensure that the fabric filter is NOT installed in the
recovery tank.
▪
Never allow the liquid to exceed maximum level in recovery tank; i.e. when the float inside the
machine rises to the vacuum cleaner head causing suction to be cut off, immediately empty
the recovery tank.
▪
For dry use the fabric filter bag must be fitted to protect motor.
2.
OPERATION
2.1
Assembling Your Machine
▪
Open the clasp and lift off the suction head.
▪
Take the accessories out of the tank if they are packed this way.
▪
Replace the suction head on the tank and close the clasp.
2.2
Preparation For Use
▪
Fit the hose into the suction hose connection until it clicks.
▪
Assemble the suction tubes and fit to the hose.
▪
Fit correct accessory to suction tube.
2.3
Filter Usage
▪
Fit fabric filter in tank for suction of dry dust.
▪
Remove fabric filter from tank for suction of liquids if your machine is a wet/dry model.
2.4
After Use
▪
Empty tank after use.
▪
Shake filter bag to dislodge dust before removing from tank.
NB. Vacuum cleaners with 2 or 3 motors can be used with 1 or more motors.
3.
NORMAL CARE & MAINTENANCE
ATTENTION: Remove plug from socket before any maintenance operation on
▪
Clean the machine inside and outside.
▪
Check the filter bag for holes or signs of wear and tear to avoid microscopic particles entering
your motor.
▪
Empty and clean filter bag after every use. NB. If you clean the filter with water, ensure that it
is dry before you replace it.
▪
Clean the rubber which is in the cover of the head.
▪
Check the hoses and the electric cable.
▪
We recommend that the carbon brushes on your motor are replaced every 200 hours.
May 2015
WARNING – This appliance must be earthed!
the head of the machine.
Aussie Eco-Clean Industrial Wet/Dry Vacuum Cleaners
3