Australion monitor AMC60 Manuel d'installation et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Australion monitor AMC60. Australion monitor AMC60 12 pages. Amc series 30w/60w/120w/250w mixer amplifiers

Imprimer la page

I N S TA L L AT I O N

MOUNTING

When rack mounting, it is advisable to allow 1 rack space above and

below the ampliﬁ er. When multiple ampliﬁ ers are mounted in a rack,

exhaust fans should be used on the rack. Airﬂ ow for cooling the AMC30,

AMC60 & AMC120 is by convection from bottom to top. Airﬂ ow for cooling

the AMC250 is by fan from front to back.

OUTPUT

DISTANCE

100V

Up to 50m

50m–200m

Over 200m

70V

Up to 50m

50m–200m

Over 200m

4 ohm

Up to 10m

10m–30m

Over 30m

PA G E 6

AMC30

AWG26(0.12mm2)

AWG24(0.2mm2)

AWG20(0.5mm2)

AWG18(0.75mm2)

AWG26(0.12mm2)

AWG20(0.5mm2)

AWG18(0.75mm2)

AWG13(2.5mm2)

Not Recommended

LINE OUTPUT

he LINE output XLR can be used to connect up to 6 booster ampliﬁ ers. Balanced wiring

(shielded pair cable) is recommended.

TAPE OUTPUT

The TAPE output wiring should be kept as short as possible.

INPUT CONNECTIONS

For wiring balanced in, pin 2 is hot. Unbalanced wiring on the microphone inputs is not

recommended. Balanced input wiring (shielded pair cable) is recommended.

Unbalanced RCA wiring should be keep as short as possible.

A M C S E R I E S I N S TA L L AT I O N & O P E R AT I O N M A N U A L

OUTPUT CONNECTIONS

DIRECT OUTPUT

The output terminal strip accepts wire sizes from 16-22AWG

(1.5mm2 – 0.35mm2) or spade lugs.

The following table should be used as a guideline for cable sizes.

Regulations in your area may require different gauged wire and should

be checked before using.

WIRE SIZE

AMC60

AWG20(0.5mm2)

AWG24(0.2mm2)

AWG16(1.5mm2)

AWG13(2.5mm2)

NOTE: Only connect one output - either Distributed Line

or Low Impedance.

NOTE: When wiring the LINE output as unbalanced, Pin2 should

be wired as hot and Pin1 should be wired as ground/shield.

Do not wire Pin3.

AMC120

AWG24(0.2mm2)

AWG22(0.35mm2)

AWG18(0.75mm2)

AWG16(1.5mm2)

AWG13(2.5mm2)

AWG22(0.35mm2)

AWG18(0.75mm2)

AWG16(1.5mm2)

AWG13(2.5mm2)

AWG10(6.0mm2)

AWG18(0.75mm2)

AWG13(2.5mm2)

AWG13(0.35mm2)

Not Recommended

AMC250