Agri-Fab 45-02212 Manuel du propriétaire - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Agri-Fab 45-02212. Agri-Fab 45-02212 16 pages. 38"

Imprimer la page

CLEAN SWEEPER

1. Clean sweeper housing with a soft brush or cloth.

2. Clean debris from hopper bag with a brush or

broom.

3. Remove any material which has wrapped around

brushes or ends of brush shaft.

CLEAN/LUBRICATE WHEEL GEARS

Every two years remove the wheels and clean the

gears found inside the wheel housing. After clean-

ing, lubricate with an even coat of light grease. To

remove the wheel, pop off the hub cap using a

screwdriver, remove the lock nut and flat washer

and then the wheel. See figure 24.

HEX BOLT

FLAT WASHER

SPACER

FIGURE 24

STORAGE

CAUTION: Before storing the sweeper,

always empty the hopper bag to avoid

spontaneous combustion.

1. Clean the sweeper and hopper bag thoroughly to

help prevent rust and mildew.

2. To collapse the hopper bag for storage, remove the

two hopper support rods from the rear of the

hopper.

3. Store in a dry area.

HEX LOCK NUT

HUB CAP

SERVICE/ADJUSTMENTS

RATCHET GEAR/DRIVE PIN REPLACEMENT

IMPORTANT: Do not remove both wheels at the

same time to avoid mixing of parts. (The R.H. and

L.H. ratchet gears are not interchangeable.) Make

notes on the position of washers and snap rings

during disassembly.

1. Remove one wheel from the sweeper.

2. Remove the retaining rings and washers which

hold the ratchet gear onto the brush shaft.

3. Remove the gear by sliding it off the brush shaft.

(Look for the drive pin, which may fall out of the

brush shaft when the ratchet gear is removed.)

See figure 25.

4. To reassemble, insert the drive pin through the

hole near the end of the brush shaft. Make sure the

pin slides back and forth easily in the shaft.

5. Lightly grease the shaft and fill the ratchet gear

with grease. Assemble the gear back onto the

shaft.

6. Lightly grease the axle and the wheel's gear teeth

and then reassemble the wheel. The brushes should

rotate only during forward rotation of the wheel. If

the brushes are driven (rotated) by reverse rota-

tion of the wheel, either the RH and LH ratchet

gears have been switched or the drive pin is jam-

ming in the ratchet gear. Clean and lubricate the

drive pin and the ratchet gear to prevent jamming.

FIGURE 25