Bend-Pak HD-12LSX Manuel d'installation et d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Bend-Pak HD-12LSX. Bend-Pak HD-12LSX 20 pages. 12,000 pound capacity four-post lift
Imprimer la page
2. Manually clear the SLACK SAFETY lock devises
on the end of each cross tube and slide the cross
tubes down until they rest on the safety lock position
fourth down from the top of the column. (See Fig. 2)
Fig. 2
3. The columns and cross bars will now be in
position and spaced properly for the runways. Be
very careful not to disturb the columns and cross
tubes at this time as they may tip over causing
personal injury or harm. (See Fig. 3)
4. With the columns and cross tubes in place,
secure the column TOP CAPS using the 3/4" hex-
nuts & washers. Be sure to position the cable hole
INWARD. (See Fig. 4)
Fig. 3
Fig. 4
( Anchoring The Columns )
1. Before proceeding, double check the measure-
ments and make certain that the bases of each
column are square and aligned with the chalk line.
2. Using the baseplate on each column as a guide,
drill each anchor hole approximately 4-1/2" deep
using a rotary hammer drill and 3/4" concrete bit.
( See Fig. 5 )
Fig. 5
3. After drilling, remove dust thoroughly from each
hole using compressed air and/or wire brush. Make
certain that the columns remain aligned with the
chalk line. Always wear safety goggles.
4. Assemble the washers and nuts on the anchors
then tap into each hole with a hammer until the
washer rests against the baseplate. Be sure that if
shimming is required, enough threads are left
exposed. ( See Fig. 6 )
Fig. 6
5. If shimming is required, insert the shims as
necessary under the baseplate so that when the
anchor bolts are tightened, the columns will be
plumb. ( See Fig. 7 )
7
STEP 4