Bendel Werkzeuge GmbH & Co. KG Tornador STEAM Manuel d'instruction original - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction original pour {nom_de_la_catégorie} Bendel Werkzeuge GmbH & Co. KG Tornador STEAM. Bendel Werkzeuge GmbH & Co. KG Tornador STEAM 9 pages.
Imprimer la pageSeite 14 von 19
3. CONTROL PANEL
1. Main switch ON/OFF
2. Display
3. Steam regulator
4. Plug Socket
5. Water tank cap
4. Operation
4.1 Preparation
•
Open the cap (5) by pulling it up and till the cold-water tank with tap water
•
Plug the steam-hose in to the plug socket
•
Connect the electrical plug to a grounded electrical outlet and push the main switch (1) to ON.
The appliance is provided with a power cord according to its electrical input
characteristics. It's important to verify that the electrical mains are according to the
norms. It is strongly recommended, that the power supply of this appliance is
equipped with an earth leakage circuit breaker (ELCB) of 30 mA maximum. Ask an
authorized electrician, if you are unsure.
4.2 Starting
•
When the pump has filled up the boiler, the boiler starts heating up (about 5 minutes).
When the display shows temperature 160 C. the STEAMER is ready for use. The
best results will be reached at approx. 170 C.
Push the trigger on the handle and direct the steam jet towards the area which has to be
cleaned.
Before starting steam cleaning, blow off the initial condensation of the conducts
into a bucket or any other suitable place.
Tornador• STEAM
BedienungsanleitungfInstruction Manual
04.10.2018