BENDIX RV-4 PRESSURE REDUCING VALVE Description générale - Page 3

Parcourez en ligne ou téléchargez le pdf Description générale pour {nom_de_la_catégorie} BENDIX RV-4 PRESSURE REDUCING VALVE. BENDIX RV-4 PRESSURE REDUCING VALVE 4 pages. Pressure reducing valve

Imprimer la page
6
4
5
10
12 & 13
11
14
15
23
16
24
22
21
20
19
Key No.
Description
1
Screw
2
Cover
3
Exhaust Diaphragm
4
Cap Screw
5
Lock Washer
6
Cover
7
Control Piston
8
Retaining Ring
9
Inlet/Exhaust Assy.
FIGURE 2
4. Remove large retaining ring from body (8) and remove
inlet/exhaust valve assembly (9).
5. Remove retaining ring from inlet/exhaust valve assembly.
Remove o-ring retainer (11), remove inner and outer
o-rings (12 & 13) from retainer. Remove spring (14) and
spring seat (15) from valve body (16).
6. Remove four cap screws (17) with lockwashers (18) from
opposite end and remove cover (19).
7. Remove shims (20) and inner (21) and outer (22) springs.
8. Remove balance piston (23). Remove o-ring (24) from
balance piston.
9. Remove retaining ring (25) from supply port. Remove
supply adapter (26). Remove o-ring (27) from supply
adapter.
ASSEMBLY (REFER TO FIGURE 2)
Before assembly, lightly lubricate all o-rings, bores and
mating surfaces with (Bendix Pc. No. 291126) Dow Coming
55-M pneumatic grease or equivalent.
1. Install o-ring (27) on supply adapter (26), place into
supply port and install retaining ring (25).
1
2
7
Key No.
10
11
12
13
14
15
16
17
18
3
8
SUPPLY PORT
3/8" P.T.
9
18
17
Description
Retaining Ring
O-Ring Retainer
O-Ring
O-Ring
Spring
Spring Seat
Valve Body
Cap Screws
Lockwashers
2. Install o-ring (24) on balance piston (23), place piston
into body.
3. Install inner (21) and outer (22) springs into base of
balance piston and place shims (20) on top of springs.
4. Replace cover (19) and attach with four cap screws (17)
with lockwashers (18). Torque to approximately 45 in.
lbs.
5. Install spring seat (15) and spring (14) onto inlet/exhaust
valve body (9). Install o-rings (12 & 13) onto o-ring retainer
(11) and place on top of spring (14), compress and install
retaining ring (10).
6. Install inlet/exhaust assembly (9) into valve body and
install retaining ring (8).
7. Install control piston (7) into valve body.
8. Replace cover (6) and attach with four cap screws (4)
and lockwashers (5). Torque to approximately 100 in.
lbs.
9. Install exhaust diaphragm (3) and exhaust cover (2) on
to valve cover (6) and attach with screw (1).
TESTING REBUILT RV-4
REDUCING VALVE
Perform operating and leakage tests as outlined.
26
25
27
SECTION VIEW OF SUPPLY PORT
Key No.
Description
19
Cover
20
Shims
21
Inner Spring
22
Outer Spring
23
Balance Piston
24
O-Ring
25
Retaining Ring
26
Supply Adapter
27
O-Ring
™
PRESSURE
3