BENDIX Cyclone DuraDrain Instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} BENDIX Cyclone DuraDrain. BENDIX Cyclone DuraDrain 4 pages. Trailer water separator

Imprimer la page

3. Gently tap the purge nut upside down and sideways to

dislodge possible debris taking care not to damage the

screen.

4. Blow air in the normal downward direction through the

screen to remove debris out the drain hole. Review the

warning note.

5. Inspect the o-ring for damage and replace if necessary.

Apply a small amount of barium grease to o-ring and

place it into the o-ring groove of the purge nut assembly.

Reinstall the purge nut into the Cyclone DuraDrain

using hand tools with low to moderate torque (150 in-

lbs).

6. Reapply air pressure and determine if the leak has been

eliminated.

SOLVENT CLEANING

If air leakage was not eliminated by air cleaning, the purge

nut may be cleaned in a mineral spirits parts washer. Repeat

the removal procedure steps 1 and 2 before proceeding.

7. Wash the hex purge nut in mineral spirits parts washer.

Flow solvent downward through the screen and out the

drain hole.

8. For stubborn debris, the purge nut may be soaked in

the parts washer overnight to dissolve persistent

deposits.

9. Apply a small amount of barium grease to o-ring and

place it into the o-ring groove of the purge nut assembly.

Reinstall the purge nut into the Cyclone DuraDrain

using hand tools with low to moderate torque (150 in-

lbs).

10. Reapply air pressure and determine if the leak has been

eliminated.

11. If the air leak persists, replace the entire purge nut with

Bendix service kit piece number 5013824.

™

body

™

body

Maintenance Kits ....... Piece No.

Purge Nut Service Kit ............. 5013824

Mounting Spacer Kit ............... 5014792