BENDIX AUTOVUE FLC-20 Service Data - Page 9
Parcourez en ligne ou téléchargez le pdf Service Data pour {nom_de_la_catégorie} BENDIX AUTOVUE FLC-20. BENDIX AUTOVUE FLC-20 16 pages.
Imprimer la page
DIAGNOSTIC TROUBLE CODES (DTCs) AND CORRECTIVE ACTION - CONTINUED
SPN
FMI
CAN_OR_FLI2_FWD_
1711
19
LANE_TRK_R
CAN_OR_FLI2_
1710
19
FWD_LANE_TRK_L
CAN_OR_FLI2_
7474
19
DRV_ALRT_LVL
CAN_OR_FLI2_DRV_
7475
19
ALRT_WAR_STATE
CAN_OR_VDC1_ROP_
1816
19
ENG_CON_ACTIVE
CAN_OR_VDC1_ROP_
1818
19
BRK_CON_ACTIVE
CAN_OR_VDC1_YC_
1817
19
ENG_CON_ACTIVE
CAN_OR_VDC1_YC_
1819
19
BRK_CON_ACTIVE
CAN_OR_VDC1_
5624
19
TRLR_VDC_ACTIVE
CAN_OR_AEBS_FOR_
5676
19
COL_AEBS_STATE
CAN_OR_VDC2_
1808
19
YAW_RATE
CAN_OR_VDC2_
1809
19
LAT_ACC
CAN_OR_VDC2_
1807
19
STR_WHL_ANG
CAN_OR_FLIC_LN_
9751
19
KP_ASST_EN
CAN_OR_FLIC_
9760
19
ReqActSteering
DriverPrf_Md
CAN_NO_BUS_
520195
9
CONNECT
Lane_Direction_
520196
2
Qualifier
CAN_OR_VP131_X_
520197
19
LCS_HazardDetected
Table 1 – Diagnostic Trouble Codes - Continued
DTC
Name
Description
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
CAN Out of
Range signal
Open Fault
CAN
Mismatch
in camera
CAN Out of
Range Signal
Failure Condition
1 < signal < 0
1 < signal < 0
100 < signal < 0
3 < signal < 0
1 < signal < 0
1 < signal < 0
1 <s ignal < 0
1 < signal < 0
1 < signal < 0
7 < signal < 0
3.92 < signal < -3.92
15.687 < signal <- 15.687
31.374 < signal < -31.374
1 < signal < 0
1 < signal < 0
No (non UDS) messages
present on vehicle CAN
for 250 ms at all (not
limited to messages
explicitly received by unit)
Left Right Lane
Information SAFE = Invalid
Signal < 0 OR sinal
= 2 OR signal = 3
Reset Condition
0 <= signal <= 1
0 <= signal <= 1
0 <= signal <= 100
0 <= signal >= 3
0 <= signal >= 1
0 <= signal >= 1
0 <= signal >= 1
0 <= signa l>= 1
0 <= signal >= 1
0 <= signal <= 7
Check the parameter
3.92 <= signal <= 3.92
15.687 <= signal
<= 15.687
31.374 <= signal
<= 31.374
0 <= signal >= 1
0 <= signal >= 1
At least one non-
diagnostic message
received
Left Right Lane
Information
camera connector is
SAFE = Valid
greater than 9 VDC.
0 <= signal <= 1
OR
signal = 4
Corrective Action
Check the sending
Electronic Control
Unit (ECU) for
proper function
and active faults.
set of the sensor.
Check the sending
ECU for proper
function and
active faults.
Check the sending
ECU for proper
function and
active faults.
Verify J1939 data
is on the vehicle
communications
bus bar.
Verify that the
voltage at the
Check the sending
ECU for proper
function and
active faults.
9