aFe Power 77-43010 Manuel d'instruction - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} aFe Power 77-43010. aFe Power 77-43010 12 pages. Advanced flow engineering
Imprimer la pageREMOVAL
1
Figure A
Refer to Figure A for step 1-3
Sleep Mode
Before installing your aFe Module you will have to place your vehicles ECU in sleep mode. In order to place your vehicles ECU
in sleep mode you will need to do the following:
Sep 1: If the engine is cold, open the hood, close the doors, lock the car and wait 30 seconds
Step 2: If the engine is warm, open the hood, close the doors, lock the car and wait 20 minutes
Step 3: If the engine is warm and you can't wait 20 minutes, disconnect the battery
Locating you MAP and CACT sensor
The MAP sensor is located on the elbow connecting to the OE air box. The CACT sensor is located on the
intercooler inlet side under the passenger side headlight. Notice both sensors look very similar MAKE SURE you do
not plug the jumper harness to the wrong sensor.
Page 4