dymax ECE ZIP Shutter Manuel de l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dymax ECE ZIP Shutter. dymax ECE ZIP Shutter 20 pages. For use with dymax ece flood lamp systems
Shutter Curtain Assembly Replacement
Dymax recommends that you check the ZIP Shutter curtain for wear each time you change the lamp. If it
shows any signs of wear, replace it. Additional curtain assembly replacements can be purchased through
Dymax Customer Service.
CAUTION! SHARP EDGES!
To prevent injuries, always wear gloves that are resistant to cuts when handling or installing
equipment. We recommend, at a minimum, CE Cut Level 5 gloves (included with kit).
Figure 16. ZIP™ Curtain Assembly Diagram
11
1. Remove the Flood Lamp Reflector Assembly from the ECE ZIP Shutter and flip the Shutter onto its top.
2. Remove the bottom cover of the ECE ZIP Shutter to expose the inside Roller (7) and Belt Drive Motor.
3. Manually unroll the Curtain (1) until the Curtain (1) reaches Large Limit Switch (8).
4. Loosen the Belt (6) tension by unscrewing the rear screws.
5. Remove the old Curtain (1) by removing the five screws (3) on the Roller (7) and loosening the two Side
Screws (4) on the Clamp Bar (5) and slide curtain off Belts (6).
6. Attach the new Curtain (1) to the Roller (7) and Roller Bar (2) with the 6-32 screw (3) previously removed
from the Roller.
7. Stretch the new Curtain (1) toward front of ZIP Shutter.
8. Slide the Clamp Bar (5) onto the Belt (6) where the Curtain is fully outstretched. The Curtain should be
stretched short of front Limit Switch (8).
9. Tighten the end screws 4-40 (4).
10. Manually roll up the Curtain until the Curtain reaches rear Limit Switch (8). If the Clamp Bar (5) bows,
loosen the screws (4) and allow the Clamp Bar to find its natural straightness and retighten.
11. Replace the ZIP Shutter's bottom cover.
12. Set-up the ZIP Shutter according to the ZIP Shutter directions. Tighten the Belt Tension (10) as needed to
improve Belt performance.
Dymax ECE ZIP™ Shutter User Guide
The edge of the stainless steel curtain is extremely sharp.
#
Description
1
Curtain
2
Roller Bar
3
Screws (5)
4
Side Screws (2)
5
Clamp Bar
6
Belts
7
Roller and Pulley
8
Limit Switch
9
Limit Switch Standoff
10
Belt Tension
11
Belt Drive Motor
13