dymax BlueWave 200 Instructions de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Instructions de démarrage rapide pour {nom_de_la_catégorie} dymax BlueWave 200. dymax BlueWave 200 2 pages. Handheld diaphragm valve
Également pour dymax BlueWave 200 : Manuel de l'utilisateur (16 pages), Instructions de démarrage rapide (2 pages), Instructions de démarrage rapide (2 pages), Instructions de démarrage rapide (2 pages)

BlueWave

NOTE: This replacement bulb is sold as a spare part to be used only in the relevant Dymax lamp system. Dymax sells

these bulbs for this intended use only.

Bulb replacement is easily accomplished by following the steps

below. Refer to the labeled diagrams under the light source cover.

1. Ensure that the Power Cord is unplugged from the rear of the

unit.

2. Remove the top cover from the BlueWave 200 by loosening the

four cover fasteners.

3. Unplug the Bulb and Lift the Bulb Mounting Bracket (Figure 3)

from it. Remove the Bulb from the Bulb Mount (Figure 4).

Figure 2. Bulb Installed in Bulb Mount

4. Unpack the new Bulb. Take care not to bend the flat Electrode in the center of the Bulb.

Figure 5. Bulb Package (Closed)

5. Install the new Bulb into the unit (Figure 9), plug the Bulb in (Figure 10), and tighten the two Mounting Bracket

Thumbscrews (Figure 11). Re-install the BlueWave 200's cover. Make sure that the center Electrode is positioned as

shown in Figure 12.

200 Bulb Installation Procedures

Figure 3. Lift Bulb Mounting Bracket

Figure 6. Bulb Package (Open)

Figure 1. BlueWave 200

Figure 4. Remove Bulb from Bulb Mount

Figure 7. Remove Bulb from Box

Quick Start Instructions

Figure 8. Bulb