GABOR FSM-X Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GABOR FSM-X. GABOR FSM-X 16 pages. Full swing mount for large and extra-large flat-panel displays

Imprimer la page

Attaching the Wall Bracket to Wooden Studs

Wooden studs run vertically inside the wall, 16 inches apart, behind the drywall or plaster.

The wall bracket must be mounted to a wooden stud, or the bracket could fall out and

damage your display or cause personal harm.

Use a stud finder to locate the

edges of the wooden stud, and

mark the center.

Place the wall bracket template

up to the marked locations, and

tape it to the wall. Use the

provided bubble level to make

sure the template is level before

drilling. Use a pencil to mark the

four locations as shown, and

place a piece of tape over each

mark.

Drywall

Use a 1/4-inch (6 mm) wood drill

bit to predrill the four anchor

locations as shown, 3.5 inches

(90 mm) deep, and then clean

out the debris from the holes.

Remove the template, and screw

only the top two anchor screws

into the wall, leaving a 5 mm gap

between the wall and screw's

head.

1/4 in.

3.5 in.

5 mm