GABOR Levitouch DM-550 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GABOR Levitouch DM-550. GABOR Levitouch DM-550 17 pages. Single arm monitor mount for 17 to 32 in. desktop computer monitors
Imprimer la page
Grommet (Non-edge) Installation
Important! Predrilled holes in the desktop should be between of 0.4 to 2.4 inches (10 to 60 mm)
in diameter.
1.
If you need to drill a hole in
the desktop, use a 3/8-inch
or 10 mm drill bit.
2.
Attach the notch cover
(G) to the bottom of
the base with the flat
hex screws (J). Make
sure the flat side of
the cover is even with
the edge of the base.
8
3.
Cover the hex
1
screws with the
plastic caps (M).
4.
Place the base on the desktop, and insert the
carriage bolt (I) through the top of the base
socket and the hole in the desktop. Once it's
inserted, make sure the bolt head sits flush
F
against the base's hole.
5.
Beneath the desktop, slide the clamping
flange (H) onto the carriage bolt (I), and then
slide the washer (K) onto the carriage bolt.
G
6.
Screw the hex nut (L) onto the bolt. Tighten it
J
by hand, and then use the wrench (P) to fully
tighten the clamping flange to the desktop.
N
F
G
H
I
J
K
L
M
N
1X
1X
1X
3X
1X
1X
2X
1X
1X
I
M
H
K
L
P
P
1X