509 Fabrication 509-1 OPTIMUM Manuel d'utilisation du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation du propriétaire pour {nom_de_la_catégorie} 509 Fabrication 509-1 OPTIMUM. 509 Fabrication 509-1 OPTIMUM 19 pages.
Imprimer la pageIMPORTANT WARNINGS
CAUTION: Read this manual thoroughly before starting installation. For your safety, follow the installation, operation and maintenance instructions
exactly without deviation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. If this appliance is not
properly installed, a house fire may result. Contact local building or fire officials about requirements and installation inspection in your area.
1.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE CONNECTED TO ANOTHER APPLIANCE.
2.
Do not connect this appliance to air ducts or any air distribution system.
3.
Do not install a flue damper in the exhaust venting system of this appliance.
4.
Do not use class B venting intended for gas appliances as a chimney or connector pipe on this appliance.
5.
The minimum clearances must be maintained for all combustible surfaces and materials including; furniture, carpet, drapes, clothing, wood,
papers, etc. Do not store firewood next to or touching the appliance.
6.
INSTALLATION DISCLAIMER - This stoves exhaust system works with negative combustion chamber pressure and a slightly positive chimney
pressure. Therefore, it is imperative that the exhaust system is gas tight and installed correctly. Since 509 Fabrications, Inc. has no control
over the installation of your stove, 509 Fabrications, Inc. grants no warranty, implied or stated for the installation or maintenance of your
stove, and assumes no responsibility for any consequential damage(s).
7.
Burning any kind of fuel consumes oxygen. If outside air is not ducted to the appliance, ensure that there is an adequate source of fresh air
available to the room where the appliance is installed.
WE HIGHLY RECOMMEND USING OUTSIDE AIR SOURCE IN CASE OF APPLIANCE SHUT DOWN, SMOKE WILL FILL THE ROOM.
8.
Most states require a fresh air intake at time of install.
9.
The stove will not operate using natural draft, nor without a power source for the blower and fuel feeding systems.
10.
Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or "freshen up" a fire in this heater.
Keep all such liquids well away from the heater while it is in use.
11.
CONTINUOUS OPERATION: When operated correctly, this appliance cannot be overfired. Continuous operation at a maximum burn can,
however, shorten the life of the electrical components (blowers, motors, and electronic controls), and is not recommended. Typical
approved operation would include running at the low to mid-range setting with occasional running on the maximum setting during the
coldest periods of the winter. The blower speed control should be turned to HIGH when operating the stove on the high heat setting.
12.
CAUTION:
HOT IN OPERATION. An appliance hot enough to warm your home can severely burn anyone touching it. Keep children, clothing
and furniture away. Contact may cause skin burns. Do not let children touch the appliance. Train them to stay a safe distance from the unit.
13.
APPROVED FUEL: This appliance is designed specifically for
hulls, cherry pits, corn, etc. regardless if it is in log form. Failure to comply with this restriction will void all warranties and the safety listing of
the stove. Consult with your authorized 509 Fabrications, Inc. dealer for more information on approved densified log fuels.
14.
FLY ASH BUILD-UP: For all densified fuel heaters, the combustion gases will contain small particles of fly ash. This will vary due to the ash
content of the fuel being burned. Over time, the fly ash will collect in the exhaust venting system and restrict the flow of the flue gases. The
exhaust venting system should be inspected regularly and cleaned as necessary.
15.
SOOT FORMATION Incomplete combustion, such as occurs during startup, shutdown, or incorrect operation of the room heater will lead to
some soot formation which will collect in the exhaust venting system. A precautionary inspection on a regular basis is advisable to determine
the necessity of cleaning. The exhaust venting system should be inspected regularly and cleaned as necessary.
16.
DISPOSING OF ASHES: Any ashes removed from the stove must be deposited in a metal container with a tight-fitting lid. The closed container
of ashes should be placed on a noncombustible floor or on the ground, well away from ail combustible materials, outside of the dwelling
pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed
container until all cinders have been thoroughly cooled.
17.
SAVE THESE INSTRUCTIONS.
18.
See the listing label on the appliance or see Safety / Listing Label
19.
When you light the stove for the first time you will get some smoke and odor off of the stove as it heats up and the paint cures. It is
recommended that you open the windows in the room where you are burning the stove to let the vapors escape. After lighting the stove for
the first time, slide the damper on the side of the stove to the "High" setting and run for at least 3 hours to let the stove paint cure.
densified wood fuels
only. This appliance is NOT approved to burn cardboard, nut