GABOR UPM-360 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GABOR UPM-360. GABOR UPM-360 12 pages. Universal projector mount

Imprimer la page

Wood Studs

Wood studs run vertically inside the wall or across the ceiling, behind the drywall

or plaster. The plate must be mounted to a wood stud, or the plate could fall out

and damage the projector or cause personal harm. Make sure the studs are at

least 1.5 inches (38 mm) wide..

1. Use a stud finder to locate the edges of the

wooden stud.

2. Mark the centerline of the stud.

3. Place the mounting plate at the location marked

for your projector, and mark the spot of the two

mounting plate holes for drilling. Make sure this is

on the center line of the stud.

4. Use a 3/16-inch (4 mm) wood drill bit to predrill

the two marked spots for support holes 2-inches

(50 mm) deep, and then clean out the debris.

5. Attach the plate by inserting the 50 mm anchor screws through the washers

and mounting plate holes and screwing them into the predrilled support holes

until secure.

1.5 in.

Drywall

2 in.