Benedini TBS Micro V2.0 Manuel
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Benedini TBS Micro V2.0. Benedini TBS Micro V2.0 9 pages.
Imprimer la page
RC Connection
Speaker
Prop 1
Prop 2
Prop 3
Polarity: - + Sinal
Technical datas:
Dimensions:
Voltage:
Current:
Speaker:
Output power:
Proportional inputs: Positiver Impuls 0,8ms bis 2,0ms
Sound quality:
Connections:
LS:
Speaker or external amplifier
PROP_1:
Prop.input for speed controller
PROP_2:
Prop.input for special functions (configurable)
PROP_3:
Prop.input for controlling.
Used for 12position encoder or two position toggle Switch.
LRN:
Bridge to enter the learn mode.
Attention: Don't solder wires at this contacts, because they are also used for
connecting the optional programming adaptor.
Prog:
Connector for the optional programming adaptor
Note:
Prog cable must be connected with its BROWN wire at the outer (right) side
of the PCB (see last page)
Power is provided through the receiver by one of the PROP inputs.
Set controlmode at delivery:
O Encoder (→ see page 3)
O Indirekt soundselect (→ see page 6)
Loaded sound at delivery: _______________________________________
Soundmodule TBS Micro V2.0
RC - Soundunit TBS Micro V2.0
PWM2 PWM1 A9 A8 A7 A6
NC A1 A2
11 x 23,5 x 3,2mm (min.11x16x3,2mm)
3V to max. 5V! (supplied by the receiver)
app. 10mA without sound, app. 250mA at max. volume
8-32 Ohm
1W at 8-Ohm at 5V,
up to 22,05 kHz
A5
A4
A3
Learn Kontakte
0,6W at 8-Ohm at 3V
O Direct soundselect (→ see page 5)
O Autostart (→ see page 7)
Page:1
Solderpads
Speaker
Ground
Prop1
Prop2
Prop3
+5V