Benedini TBS Mini Manuel de données techniques - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de données techniques pour {nom_de_la_catégorie} Benedini TBS Mini. Benedini TBS Mini 11 pages. Digital multifunctional rc-soundunit
Également pour Benedini TBS Mini : Manuel (11 pages), Manuel (11 pages)
Imprimer la page
2. Connection
Plugs (from top to bottom)
1.
8 Ohm speaker or ext. amplifier
2.
Prop1 Input (RX IN)
3.
Prop1 Output (ESC OUT)
4.
Prop2 Input (RX)
5.
Prop3 Input (RX)
6.
PWM1 (Servosignal 1) or Out 10
7.
PWM2 (Servosignal 2) or Out 11
8.
Out 1+2 switching output
9.
Out 3+4 switching output
Attention:
All plugs must be connected with the orange or white signal lead on TOP and the
negative supply lead (brown or black) at BOTTOM !!!!
Speaker
PROP 1
/ Ampl.
In
Speaker
Signal
(Input)
Plus
Speaker
Power
Minus
Ground
Ground
Speaker connection:
If a speaker is connected directly to the TBS Mini, make sure to use the Speaker Plus and Speaker
Minus pins (upper two pins). You must NOT use the Ground pin at the speaker connector!
Use only an 8 Ohm speaker.
Switching outputs (Out 1..4, Out10, Out11)
All outputs are switching to NEGATIVE of the receiver supply voltage. Positive is available at the
centre pins of the according plugs.
Out 10 is available at the PWM1 plug
Out 11 is available at the PWM2 plug
TBS Mini
PROP 1
PROP 2
Out
In
Signal
Signal
(Output)
(Input)
Power
Power
Ground
Ground
www.benedini.de
PROP 3
PWM 1
(OUT10)
In
Signal
Signal
(Input)
(Output)
Power
Power
Ground
Ground
Top: Signal (orange)
Center: Power (red)
Bottom: GND (black)
OUT
1+2
PWM 2
(neg.
(OUT 11)
switch-
ing)
Signal
OUT 1
(Output)
(negative)
Power
Power
Out 2
Ground
(negative)
Page 3 of 11
Learn Button
Prog. Cable
OUT
3+4
(neg.
switch-
ing)
OUT 3
(negative)
Power
OUT 4
(negative)