Dymo KeepnTrack Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dymo KeepnTrack. Dymo KeepnTrack 16 pages. Badge printer

2. Use the lint-free cloth to wipe the exterior of the printer.

3. Remove dirt and smudges with one of the cleaning solutions mentioned above.

4. Open the top cover.

5 . Use a small, soft brush or cotton swab to whisk away paper dust and other stray particles from

the inside of the printer.

6 . Remove the roll of labels and clean under the roll.

7. If you have a LabelWriter cleaning card, follow the instructions printed on cleaning  

card packaging.

8. Reconnect the power cord and reload the roll of labels.

Other Common Errors

• DYMO LabelWriter 400 is not set up on this computer or Printer not Recognized

-The printer is not named properly. Supported names are: DYMO LabelWriter 400, DYMO

LabelWriter 450, DYMO LablelWriter Twin Turbo

• 'undeﬁned' is not a function

- Completely close and restart your browser. If this does not correct the error condition the browser

version you are running may need to be ran in 32 bit mode.

• Automation Server Can't Create Object OR To print labels or slips, you must install the most

current DYMO Label Software

- Either the current software has not been installed correctly as outlined above, the printer plugin

has not been authorized in the browser, or the printer plugin has been disabled in the browsers

add-on management. When you are prompted by your browser to allow the KeepnTrack Webpage

to run the DYMO plugin (DLS SDK COM Library, DYMO Label Framework IE Plugin, etc.) authorize it

permanently. These messages vary from browser to browser but they will all have a similar

message (Image 16).

It may be necessary to visit your browsers Add-Ons management to enable the plugin if you

previously disabled or disallowed it (Image 17).

IG0080.8 - v6010 Badge Printer!

Image 16